Rabbit L5-2.5L (BGP) (2006)
-
Coat sealing rings -1- with coolant before installing.
-
Insert sealing rings -1- into connection on heater core.
NOTE:
-
Ensure sealing rings are installed on the proper side, as shown in the illustration.
-
If pipe clamps are deformed, replace them.
-
Connect coolant pipes to heater core.
-
Pipe clamps -A- must be able to be twisted slightly when installing onto the coolant pipes.
-
Pipe clamps -A- must be installed as shown in the illustration.
-
Tighten pipe clamps -A- to 2.0 Nm.
-
Check seating of both clamps -A- after tightening screws, clamps must enclose the flange on heater core and coolant pipe completely and must not
touch other components.
-
Tighten screw -1- (6 mm hex socket head) on connecting flange between heater core connections to 2 Nm.