Rabbit L5-2.5L (BGP) (2006)
Thermostat: Service and Repair
Coolant thermostat, removing and installing
Special tools, testers and auxiliary items required
^
Refractometer T10007
^
Drip tray V.A.G 1306 or drip tray for workshop crane VAS 6208
^
Torque wrench V.A.G 1331
^
Spring-type clip pliers VAS 5024 A
Removing
CAUTION: Hot steam may escape when opening expansion tank. Wear protective goggles and protective clothing to prevent damage to eyes
and scalding. Cover cap with a rag and open very carefully.
-
Drain coolant.
-
Remove engine cover with air filter.
-
Remove intake manifold.
-
Insert guide tube for oil dipstick into cylinder block again and install tightly so that no escaping coolant can run into engine.
-
Place a suitable container under coolant regulator housing to catch coolant flowing out.