Rabbit L5-2.5L (BGP) (2006)
^
Only replace as set
^
Affiliation to cylinder mark - B -
^
Installed location: Markings - A - point to belt pulley side
7. Circlip
8. Piston pin
^
If difficult to move, heat piston to 60° C
9. Piston
^
Checking
^
Mark installed position and cylinder allocation
^
Arrow on piston face points toward belt pulley side
^
Install with piston ring compressor
^
Cylinder bore, checking
10. Piston rings
^
Offset gaps by 120°
^
Use piston ring pliers for removal and installation
^
Markings face toward piston crown
^
Checking ring gap
^
Check piston ring groove clearance
Bearing shells - installed positions
Bearing shell - 1 - with oil bore - arrow - for connecting rod.
Bearing shell - 2 - without oil bore for connecting rod cover.
-
Center bearing shells into connecting rod and connecting rod cap.
Dimension - a - must be the same at left and right.