Rabbit L5-2.5L (BGP) (2006)
-
Insert assembly device T10122/1 onto pull sleeve T10122/2 and slide sealing ring - A - onto pull sleeve.
-
Remove assembly device T10122/1.
-
Install pull sleeve T10122/2 with sealing ring - A - onto crankshaft.
-
Press in sealing ring all around evenly and flush using pressure sleeve T10122/3.
The rest of installation follows reverse of removal procedures. Note the following:
^
Remove locking pin T40069 from cylinder block at rear and install screw plug.
Tightening torques