Rabbit L5-2.5L (BGP) (2006)
-
Place plastic sleeve - A - on valve stem to prevent damage to new valve stem oil seals - B -.
-
Oil sealing lip of valve stem oil seal - B -, insert into valve stem seal driver 3365 and carefully slide onto valve guide.
-
Remove plastic sleeve - A -.
-
Insert valve spring and valve spring retainer.
-
Install valve cotter disassembly and assembly device VAS 5161 as shown.
Intake side
Exhaust side
Note:
^
If the valve keepers were removed from the installation cartridge, they must be inserted into valve insertion device VAS 5161/18 next.
^
Press installation cartridge VAS 5161/8 onto insertion device from above and take up valve keepers.
-
Press down installation cartridge VAS 5161/8 using pressure fork VAS 5161/2, knock lightly against installation cartridge in lower area, rotate