Rabbit L5-2.5L (BGP) (2006)
-
Removing and installing.
6 - Oil pump drive chain
-
From Model Year (MY) 2008 the roller chain has been changed to a toothed chain.
-
Removing
-
Remove the engine. See: Service and Repair/Removal and Replacement
-
Remove the control housing cover. See: Timing Cover/Service and Repair
-
Remove the timing chain. See:
-
Remove the chain tensioner - item 3 -.
-
Mark direction of travel.
-
Note when installing: Install in original direction of travel.
-
Chain must lay correctly in the tensioning and guide rails.
-
Adjust the valve timing.
7 - Bolt, 20 Nm + 90° (1/4 turn) additional turn
-
Always replace.
8 - Guide rail
-
Lubricate the pin before installing.
9 - Bolt, 10 Nm
10 - Axial bearing disc
-
Engages in groove of the double wheel sprocket- item 12 - .
11 - Bolt, 60 Nm + 90° (1/4 turn) additional turn
-
Always replace.
12 - Double wheel sprocket
-
Lubricate the journal before installing.
-
Oil groove for axial bearing disc - item 10 -.
13 - Journal for the double wheel sprocket
14 - Pin, 40 Nm
-
For the timing chain tensioner.