Rabbit L5-2.5L (BGP) (2006)
-
Using a Multimeter, check the following wiring connection for an open circuit.
Camshaft Adjustment Valve
Motronic Engine Control Module (ECM)
N205 electrical harness
J623 electrical connector T121 terminal
connector terminal
or test box socket
2
115
1
Fuse 24 (On fuse panel B)
Specified resistance 1.5 Ohms max.
If the specification Is not obtained:
-
Check the wiring for a short circuit to Battery positive (+) or an open circuit.
-
If necessary, repair the wiring connection.
If no malfunctions are found in the wiring:
-
Replace the Motronic Engine Control Module (ECM) J623.
Assembly is performed in the reverse order of removal, note the following:
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 03: Interrogating Fault Memory
2. If necessary, erase the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 04: Reset/Delete Diagnostic Data
3. If the DTC memory was erased generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
-
End of diagnosis.