Rabbit L5-2.5L (BGP) (2006)
Control Assembly: Service and Repair
Heating and A/C Controls, Removing and Installing
Heating And A/C Controls, Removing And Installing
Removing:
CAUTION:
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
NOTE:
-
Heating and A/C controls consist of two separable housings. Before removing controls, set rotary control knobs to the following positions:
-
Heater control to "cold"
-
Blower control to "0"
-
Air flow control to "footwell"
-
Remove radio.
-
Remove long screws -2- and short screws -3- and remove controls -1- from center console.
Tightening torque for screws -2- and -3-: 1.5 ±0.2 Nm
-
Disengage electrical connection retainer -A- by pulling in direction of -arrow 1-.
-
Disengage electrical connection retainer -B- to connector -arrow 2- and disconnect electrical connection -C-.
-
Disengage electrical connection retainer -D- and disconnect electrical connection -D-.
Installing:
Install in reverse order of removal, ensuring rotary control knobs have not been moved from the positions as specified for removal.