Rabbit L5-2.5L (BGP) (2006)
-
Check position of grommet -C- in bulkhead for proper seating.
-
Seal flange for coolant pipes to heater core -A- and for expansion valve (to evaporator, only in vehicles with A/C system) -B- at grommet
pass-through -C- with silicon adhesive sealant if necessary (to prevent water from penetrating).
NOTE:
-
Sealing rings must always be replaced.
-
After replacing heater core, coolant must be replaced completely (refer to applicable engine).
-
Check coolant circuit for leaks, pay particular attention between coolant hoses and heater core.