Rabbit L5-2.5L (BGP) (2006)
CAUTION:
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
NOTE: To improve accessibility, additional components e.g. engine cover must be removed (depending on engine version).
-
Remove instrument panel
-
Remove facing wall in plenum chamber.
-
Remove left and right rear footwell channels
-
Place Drip tray for VAS6100 VAS 6208 under the engine.
-
Mark coolant hoses -1-
CAUTION:
-
Scalding danger.
-
The cooling system is pressurized when the engine is warm. Wear gloves and other protection and carefully release system pressure if
necessary before performing repairs.
-
Clamp off coolant hoses -1- using Hose clamps, up to 40 mm. 3093 and disconnect coolant hoses to heater core.
-
Connect a section of hose -A- onto upper connection of heater core.
-
Hold a container -B- under the lower connection -C-.
-
Using a compressed air gun, carefully blow residual coolant from heater core at heater core connection.
-
Cover floor carpet in vehicle interior with leak-proof foil and absorbent paper.
NOTE: Take note during removal of the length and assignment of screws for re-installation