Rabbit L5-2.5L (BGP) (2006)
Discharge Air Temperature Sensor / Switch: Service and Repair
Footwell Outlet Temperature Sensor G192, Removing and Installing
Footwell Outlet Temperature Sensor G192, Removing And Installing
Removing:
-
Remove instrument panel
-
Remove Data Bus On Board Diagnostic Interface J533.
-
Remove left footwell vent.
-
Remove bolts -1- and -3-.
-
Remove bracket -2-.
-
Disconnect connector at Footwell Outlet Temperature Sensor G192 -1-.
-
Rotate Footwell Outlet Temperature Sensor G192 90 degrees and remove from housing.
Installing:
Install in reverse order of removal.