Rabbit L5-2.5L (BGP) (2006)
/Page-2676002.png)
-
Rotate bulb retainer -1- in direction of -arrow- and remove.
-
Carefully remove bulb -1- from mounting.
Installing:
CAUTION:
-
Do not touch glass portion of HID bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that
evaporates on the bulb during operation can cause the glass to cloud over.
-
When installing lamp retainer, ensure HID bulb is seated correctly in mounting.
-
When installing cap, ensure proper seating. Water intrusion will damage headlamp.
CAUTION:
-
HIGH VOLTAGE.
-
Danger of explosion and burning.
-
The control modules for HID lamps must never be operated (headlamps turned on) without an HID lamp.
-
HID bulbs must only be operated (headlamps turned on) when installed in the headlamp housing.
-
Never look directly at an operating HID bulb. The UV emissions of an HID bulb are approximately 2.5 times that of a comparable
halogen bulb..
-
Insert bulb into mounting.
-
Secure bulb by rotating bulb retainer in direction opposite to that during removal.
-
Insert igniter unit onto bulb terminal and rotate to "CLOSE" position.
-
Reconnect igniter unit electrical connection -1-.
-
Refit rear lamp housing cover.
-
Install headlamp
-
Check HID Lamp function.
