Rabbit L5-2.5L (BGP) (2006)
-
Remove rear lid Tail lamp assembly mounting nuts -1-.
-
Remove Tail lamp assembly.
Installing:
Install in reverse order of removal, noting the following:
-
Secure washer -2- using a glue dot (e.g. Loctite) before inserting onto bolt head -1- to prevent them from falling into body.
-
Insert washers -2- onto bolt head -1-.
-
Tighten mounting nuts -1- to specified tightening torque.
-
Check gap dimension to body after installing Tail lamp assembly.
Rear Lid Taillamp Assembly Lamp Carrier, Removing and Installing
Rear Lid Taillamp Assembly Lamp Carrier, Removing And Installing
Removing:
-
Switch off ignition, switch off all electrical consumers and remove ignition key.