Rabbit L5-2.5L (BGP) (2006)
-
On vehicles through 10.05 production, alignment of rear light assembly to bumper cover is not possible.
-
On vehicles from 11.05 production, check and align rear light assembly relative to bumper cover.
Rear Lights In Rear Fender Through 10.05, Replacing
Rear Lights In Rear Fender Through 10.05, Replacing
Special tools, testers and auxiliary items required
-
Torque Screwdriver VAG 1624 (or locally available equivalent)
NOTE: Replacement rear light assemblies may or may not be available as originally installed in production. As a result, it may be necessary to install
replacement rear light housing using a non-adjustable adapter that ensures proper fit between the body and the rear light (adapter takes up space due to
different housing configuration). In these cases, use the following procedure:
-
Remove rear light.
-
Adapter mounts to area indicated by -arrow-.
-
Install adapter -2- to replacement rear light housing -1- as illustrated.
-
Install and tighten screw -3- to specified tightening torque:
-
Install rear light.
Rear Lights In Rear Fender From 11.05, Replacing
Rear Lights In Rear Fender From 11.05, Replacing
Follow the same procedure as Rear lights in rear fender, removing and installing.
Rear Lights In Rear Fender From 11.05, Adjusting