Rabbit L5-2.5L (BGP) (2006)
-
Disconnect electrical connection -1- in direction of -arrow-.
-
Remove lower rear lid trim.
-
Remove nuts -1-.
-
Remove rear light housing.
Installing:
Install in reverse order of removal, noting the following:
NOTE: To prevent washer from falling into body during installation, secure washer -2- to threaded stud -1- with adhesive before installing.
-
Insert washers -2- onto threaded stud -1-.
-
Insert rear light assembly to opening in rear lid
-
Install and tighten nuts -1- to specified tightening torque.