Rabbit L5-2.5L (BGP) (2006)
-
Press button "02 - Check DTC memory" on display.
-
If no malfunction is stored in engine control module, "0 DTC(s) detected" is displayed.
-
If malfunctions are stored in engine control module, these are shown one below another on display.
-
Press <- key.
-
Press button "05 - Erase DTC memory" on display.
-
Press function "06 - End output" .
NOTE: If DTC memory was erased, readiness code must be generated again Vehicle Diagnosis, Testing and Information System VAS 5051
"Guided Functions".