Rabbit L5-2.5L (BGP) (2006)
-
Replace Intake Air Temperature (IAT) Sensor G299.
If the specification is obtained:
-
Replace the Engine Control Module (ECM) J623.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. See: Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 03: Interrogating Fault Memory
2. If necessary, erase the DTC memory. See: Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 04: Reset/Delete
Diagnostic Data
3. If the DTC memory was erased, generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
-
End of diagnosis.