Rabbit L5-2.5L (BGP) (2006)
-
Pry protective housing upward using screwdriver - A - and pull it off sideways from retaining plate - arrow - .
-
Disengage forward harness connector - 1 - from Engine Control Module (ECM) and disconnect it.
-
Pry up locking mechanism - 2 - slightly.
-
Slide Engine Control Module (ECM) out of retainer - arrow - .
-
Disengage rear harness connector from Engine Control Module (ECM) and disconnect it.
Installing
-
Connect rear harness connector to Engine Control Module (ECM) and engage it.
-
Slide Engine Control Module (ECM) on to retaining plate.
-
Connect front harness connector to Engine Control Module (ECM) and engage it.
-
Slide protective housing on to retaining plate.
-
Tighten shear bolts -1 - uniformly until bolt heads shear off.
-
Install plenum chamber bulkhead.
-
Install wiper arms and plenum chamber cover.