Rabbit L5-2.5L (BGP) (2006)
1
6
2
Fuse 29 (on fuse panel C, in cabin, L.H. side)
3
27
4
53
5
29
Specified resistance 1.5 Ohms max.
If the specification is not obtained:
-
Check the wiring for a short circuit to Battery positive (+) or an open circuit.
-
If necessary, repair the wiring connection.
If no malfunctions are found in the wiring:
-
Replace Mass Air Flow (MAF) Sensor G70.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. See: Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 03:
Interrogating Fault Memory
2. If necessary, erase the DTC memory. See: Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic
Mode 04: Reset/Delete Diagnostic Data
3. If the DTC memory was erased, generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes
-
End of diagnosis.