Rabbit L5-2.5L (BGP) (2006)
Similar screen appears:
-
Turn ignition switch to the crank position and observe that the last bit cycles from "0" to "1", as shown.
Tip: Example of switch in crank position: 01011
If the bit does not cycle, then verify the integrity of the ignition switch (further diagnostics are needed. DO NOT continue with this Technical
Bulletin).'
-
Exit address word 16
-
Steering Wheel Electronics.
-
Enter address word 09
-
Electronic Central Electrics.
-
Read Measuring Value Block 7.
-
Turn ignition switch to the crank position again and hold.
The first field is a status indication of the Terminal 50 input on pin G1 on the Vehicle Electrical System Control Module -J519-.
Similar screen appears:
-
If this does not cycle from "OFF" to "ON" , as shown, when in the crank position then the Vehicle Electrical System Control Module -J519- is not
receiving a Terminal 50 input from the Steering Column Electronic Systems Control Module -J527-.
Verify Terminal 50 circuit and connector terminals between Vehicle Electrical System Control Module -J519- and Steering Column Electronic Systems
Control Module -J527-.
Circuit path: Pin 1 on the 12 pin G connector of Vehicle Electrical System Control Module -J519- to pin 18 on the 20 pin connector of the Steering
Column Electronic Systems Control Module -J527-.
Steering Column Electronic Systems Control Module -J527- located under steering column, -arrow-.