Rabbit L5-2.5L (BGP) (2006)
Impact Sensor: Service and Repair
Rear Wheel Housing Crash Sensors (2-Door), Removing and Installing
Rear Wheel Housing Crash Sensors (2-door), Removing And Installing
NOTE: Removal and installation is described for the right-hand side of the vehicle. Removal and installation for the left-hand side is performed in the
same manner.
Removing
CAUTION: Observe safety precautions for working on airbags.
-
Disconnect vehicle battery
-
Remove seat bench.
-
Remove backrest
-
Remove upper B-pillar trim
-
Remove side trim
-
Press connector lock - 1 - toward rear - arrow - and disconnect connector - 2 - from crash sensor - 4 -.
-
Remove the two bolts - 3 - (9 Nm).