Rabbit L5-2.5L (BGP) (2006)
-
Disengage socket -1- and pull it off handle part -2-.
-
Turn around handle part -2- of torque wrench 180 degrees and insert socket again.
-
Set turning direction of torque wrench to left at socket.
-
Insert a multi-point socket insert M10 -1- in generator shaft.
-
Counter hold multi-point adapter VAS 3400 using 17 mm ring wrench.
-
Tighten ribbed belt pulley with freewheel by turning generator drive shaft toward left using torque wrench VAG 1332.
-
Tighten all fasteners according to values in table.
Ribbed belt pulley with freewheel, removing and installing - Mfr: Valeo