Rabbit L5-2.5L (BGP) (2006)
Ignition Lock Solenoid: Service and Repair
Ignition Switch Key Lock Solenoid N376, Removing And Installing
Ignition Switch Key Lock Solenoid N376 is installed in the immediate vicinity of ignition/starter switch.
NOTE: To remove ignition key in vehicles with automatic transmission, always shift selector lever into position "P" and then switch off ignition.
Otherwise, Ignition Switch Key Lock Solenoid N376 prevents ignition key from being removed.
Removing:
-
Remove Steering Column Electronic Systems Control Module J527.
-
Release locking device -2- using a suitable screwdriver.
-
Pull Ignition Key Removal Lock Solenoid N376 -1- in direction of arrow out of its mount.
-
During this, harness connector is simultaneously disconnected.
Installing:
-
Install in reverse order of removal, noting the following:
NOTE: After connecting battery, perform output Diagnostic Test Mode (DTM) to activate the Ignition Switch Key Lock Solenoid N376.