Rabbit L5-2.5L (BGP) (2006)
Are any of the following DTCs stored in Fault Memory?
Yes: Follow guided Fault Finding Test Plan for repair, use table below for correct Pin assignment.
No: Follow Testing Power Supply and Grounds above.
Did the connections test OK between the Data Bus On Board Diagnostic Module Interface Module (J533 Gateway) and TCM (J217) circuits?
Yes: Test the Power Supply and Grounds circuits to Data Bus On Board Diagnostic Interface Module (J533, Gateway) and TCM (J217) listed below
Did the Power supply and Ground circuits to the Data Bus On Board Diagnostic Interface Module (J533 Gateway) and TCM (J217) test OK?
Yes: Contact technical assistance, select the "Technical Assistance" tab in Elsaweb and follow the instructions to obtain a 6 digit pin.
No: Repair harness wiring as necessary.
Warranty
Information only.
Required Parts and Tools
No Special Parts required.
No Special Tools required.
Additional Information