Rabbit L5-2.5L (BGQ) (2008)
-
Switch the ignition off.
Checking Ground (GND)
-
Using a Multimeter, check the following wiring connection for voltage.
Camshaft Position Sensor
Motronic Engine Control Module (ECM)
G40 electrical harness
J623 electrical connector T121
connector terminal
terminal or test box socket
3
Battery positive (+)
Specified value: about 10 V.
If the specified values are obtained:
-
Replace Camshaft Position (CMP) Sensor G40.
If the specified values are not obtained:
Checking resistance
-
Using a Multimeter, check the following wiring connections for an open circuit.
-
Camshaft Position (CMP) Sensor G40
Camshaft Position Sensor G40
Motronic Engine Control Module (ECM)
electrical harness connector
J623 electrical connector T121 terminal or
terminal
test box socket
Pin 3 Battery Positive (+)
108
Pin 2 Signal
86
Pin 1 Ground (GND)
98
Specified resistance 1.5 ohms max.
-
Check the wiring for a short circuit to Battery positive (+) or an open circuit.
-
If necessary, repair the wiring connection.
-
Erase the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 04 - Erase DTC Memory
-
Perform a road test to verify repair.