Rabbit L5-2.5L (CBUA) (2008)
Cowl Moulding / Trim: Service and Repair
Intake Air Grille
Intake Air Grille
Removing
-
Remove plenum chamber cover.
-
Remove cover - 1 - from plenum chamber.
NOTE:
-
From 11.05.08 with Climatronic, a bracket with an air quality sensor G238 is installed on the intake air grille .
-
Air quality sensor G238 function .
-
Release the air quality sensor G238 - 1 - and rotate it to the right to remove it from the bracket.
-
Remove the flange nuts - arrows - (2.5 plusminus 0.4 Nm) and remove the intake air grille upward.
Installing
Install in reverse order of removal.
NOTE: Seal must be seated correctly on intake air grille.
Assembly sequence:
-
Align the intake air grille on the flange.
-
Hold the intake air grille and install the side flange nuts (2.5 plusminus 0.4 Nm) and then the center flange nut.