Rabbit L5-2.5L (CBUA) (2008)
-
Remove the cable - 1 -, unscrew the mounting bracket - 2 - and lay it aside.
Continuation for All
-
Remove trim on drivers side.
Brake light switch is no longer present on mounting bracket from 11.06.05.
-
Disconnect connector - 1 - from brake light switch.
-
Remove brake light switch - 2 - by rotating 45° toward left.
-
Remove air channel - 3 -.
-
Remove cover - 4 -.
-
Disconnect brake pedal from brake booster.
-
Unscrew nuts - 1 - from brake booster.
-
Loosen both upper nuts - 2 - from the mounting bracket.
-
Carefully remove brake booster from vehicle.
Installing
-
Installation is performed in the reverse sequence.
Observe the following points when installing:
-
Clip brake pedal together with brake booster.
-
After installing, bleed brake system and clutch.