Rabbit L5-2.5L (CBUA) (2008)
Wheel Speed Sensor: Service and Repair
Speed Sensor, Rear Axle
Speed Sensor, Rear Axle (FWD)
Removing
-
Raise vehicle.
-
Separate speed sensor and speed sensor wiring connector - 1 -.
-
Remove bolt - 2 - from wheel bearing housing.
-
Remove ABS speed sensor from wheel bearing housing.
Installing
-
Before inserting speed sensor, clean hole inner surface and coat speed sensor all-round with hot bolt paste G 052 112 A3.
-
Insert the speed sensor into the hole in the wheel bearing housing and tighten the bolt to 8 Nm.
-
Connect speed sensor to speed sensor wiring.