Rabbit L5-2.5L (CBUA) (2008)
Valve Cover: Service and Repair
Cylinder Head Cover
Special tools, testers and auxiliary items required
^
Torque Wrench V.A.G 1331
Removing
-
Remove engine cover with air filter.
-
Disconnect air hose of crankshaft housing ventilation - arrow -.
-
Remove connecting pipe - A -.
-
Remove ignition coils - 1 to 5 -.
-
Remove bolts for cylinder head cover in the sequence - 16 to 1 -.
Installing
Install in reverse order of removal. When doing this note the following:
Note:
^
Replace cylinder head cover if damaged or leaking.
-
Clean sealing surfaces so they are completely free of any oil or grease.
-
Tighten cylinder head cover in sequence - 1 to 16 -.
-
Observe tightening sequence when installing connecting pipe - A -.