Rabbit L5-2.5L (CBUA) (2008)
Intake Manifold: Service and Repair
Intake Manifold
Intake Manifold
Special tools, testers and auxiliary items required
-
Torque Wrench V.A.G 1331
-
Multi-point socket T10107 A
Removing
NOTE:
-
Observe safety precautions.
-
Observe the rules for cleanliness.
-
First, check whether a coded radio is installed. If necessary, obtain the anti-theft coding.
-
Disconnect battery.
-
Remove engine cover with air filter.
CAUTION: Fuel supply line is under pressure. Wear protective goggles and protective clothing to prevent injuries and contact with skin.
Before loosening the fuel lines, place a rag around the connection point. Then release pressure by carefully pulling hose off connection.
-
Separate breather line - 1 -, vacuum line - 2 - and fuel supply line - 3 -. To release wires - 1 - and - 2 -, press the circlip in. With wire - 3 -, the
retainer must be pressed upward in the housing.
-
Disconnect connectors - 1 -, - 2 - and - 6 -.
-
Remove wiring harness - 3 - from transport strap.
-
Pull clamps - 4 - and retaining ring - 5 - out of locking mechanism.
-
Remove bolts - 7 - and remove transport strap.
-
Remove Throttle Valve Control Module J338. The coolant hoses remain attached.