Rabbit L5-2.5L (CBUA) (2008)
-
Install engaging device VAS 5161/6 with installation forks VAS 5161/5 into guide plate VAS 5161/19B.
-
Insert installation cartridge VAS 5161/8 into guide plate VAS 5161/19B.
-
Engage pressure fork VAS 5161/2 on engaging device VAS 5161/6.
Note:
^
On the exhaust side, pressure forks VAS 5161/2 must be engaged as shown.
-
Press down installation cartridge VAS 5161/8. At the same time, turn knurled bolt of installation cartridge VAS 5161/8 clockwise until the points
engage in the valve keepers.
-
Lightly move knurled bolt of installation cartridge back and forth, this causes the valve keepers to be pressed apart and captured in the installation
cartridge.
-
Release pressure fork VAS 5161/2.
-
Remove installation cartridge VAS 5161/8, valve spring retainers and valve springs.
-
Remove valve stem seals using Valve Seal Removal Tool 3364.