Rabbit L5-2.5L (CBUA) (2008)
-
Remove intake hose - 4 -. To do so, disconnect air hoses - 1 - and - 2 - (compress securing ring) and remove spring clamp - 3 -.
-
Remove front and rear sections of right front wheel housing liner.
-
Remove ribbed belt for generator and coolant pump.
-
Remove 4 nuts - 2 - and bolts - 3 -.
-
Pull off exhaust pipe - 1 - from manifold and tie up firmly to the side.
Note:
^
Flex joint in front exhaust pipe must not be bent more than 10°, otherwise it may be damaged.
-
Remove pendulum support.
With Manual Transmission
-
Remove shift mechanism from transmission.
Vehicles with automatic transmission
-
Remove selector lever cable from transmission.
-
Remove selector lever cable from transmission.
Continuation for all vehicles
-
Install engine support bridge 10-222A with adapters 10-222A/8 and support engine/transmission assembly in installation position using adapter
10-222A/3 and shackle 10-222 A/12.
Note:
^
Illustration shows the arrangement with automatic transmission.
^
In vehicles with manual transmission, spindle - A - is to be located toward rear and secured to reinforcement brace of transmission.