Rabbit L5-2.5L (CBUA) (2008)
-
Remove the noise insulation under the engine
-
Remove front right wheel housing liner
-
Remove the ribbed belt
CAUTION:
-
There is a danger of ice-up.
-
Refrigerant leaks out if refrigerant circuit is not discharged.
-
Refrigerant must be extracted before opening refrigerant circuit. If refrigerant circuit is not opened within 10 minutes of extraction,
pressure may form in refrigerant circuit due to evaporation. Extract refrigerant once more.
-
Remove the bolts (22 Nm ± 1 Nm) - 1 - from the A/C compressor and disconnect the refrigerant lines from the A/C compressor.
-
Remove the hex bolts (25 Nm) - 2 - and the A/C compressor.
Installing
NOTE:
-
Make sure alignment bushings - 3 - are seated correctly.
-
Pay attention to notes for installing A/C compressor
A/C Compressor Sub-Assembly
A/C Compressor Sub-Assembly (BGP, BGQ, CBTA, CBUA)
Special tools, testers and auxiliary items required
-
Torque wrench V.A.G 1331/ (or 5-50 Nm equivalent)
NOTE:
-
The auxiliary component bracket for A/C compressor and ancillary parts can be removed and installed without opening the refrigerant circuit.
-
To remove ribbed belt
-
Position of ribbed V-belt