Rabbit L5-2.5L (CBUA) (2008)
Discharge Air Temperature Sensor / Switch: Service and Repair
Footwell Outlet Temperature Sensor
Footwell Outlet Temperature Sensor
Removing
-
Remove instrument panel
-
Remove Data Bus On Board Diagnostic Interface J533
-
Remove left footwell vent
-
Remove the bolts - 1 - and - 3 - (9 ± 1.3 Nm).
-
Remove bracket - 2 -.
-
Disconnect connector at Footwell Outlet Temperature Sensor G192 - 1 -.
-
Rotate Footwell Outlet Temperature Sensor G192 90 degrees and remove from housing.
Installing
Install in reverse order of removal.