Rabbit L5-2.5L (CBUA) (2008)
Fuel Gauge Sender: Service and Repair
Fuel Level Sensor
NOTE: Phased-in introduction of fuel delivery units with changed Fuel Level Sensor G.
Removing (old version):
-
Remove fuel delivery unit.
-
Release connectors - arrows - and remove electrical wires - 1,2 and 3 -.
-
Lift retaining tabs - 4 - and - 5 - with a screwdriver and pull fuel level sensor G downward and off - arrow -.
Installing
-
Insert Fuel Level Sensor into guides at fuel delivery unit and press up until engagement.
-
Connect connector and check for secure locking.
-
Fuel delivery unit, installing.
Removing (new version):
-
Remove fuel delivery unit.
-
Release retaining tabs - arrows - with a screwdriver.