Rabbit L5-2.5L (CBUA) (2008)
/Page-1929002.png)
-
Remove HID Lamp Igniter Unit N195 straight back from headlamp.
-
Remove both Headlamp Beam Adjusting Motor bolts - arrows -.
-
Raise low beam reflector and pivot adjusting motor so that ball head - 1 - can slide out of ball head mount - 2 - - in direction of arrow -.
-
Lower low beam reflector again, raise adjusting motor - 1 - slightly and rotate in - direction of arrow -.
-
Remove adjusting motor from headlamp housing while being careful of connected wires.
