Rabbit L5-2.5L (CBUA) (2008)
Marker Lamp: Service and Repair
Front Side Marker Lamps
Special tools, testers and auxiliary items required
-
Trim removal wedge 3409
NOTE:
-
When removing and installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool (trim removal
wedge 3409, screwdriver) will be positioned, using commercially available adhesive tape.
-
It is not necessary to disconnect battery.
-
Illustrations show removal and installation of left Front, Side Marker Lamps M11.
-
Removal and installation of left and right Front, Side Marker Lamps M11 is the same.
Removing
-
Turn off the ignition and all electrical consumers.
-
Carefully press the side marker lamps - 1 - into the bumper cover (0.5 - 1.0 cm) - arrow -.
-
Position trim removal wedge VAS 3409 at back - arrow A - on side marker lamps - 1 - and lightly press forward in - direction of arrow B -.
-
Remove the side marker lamps - 1 - in the - direction of the arrow - from the bumper cover.