Rabbit L5-2.5L (CBUA) (2008)
-
Loosen lock nut -3-, counterhold at tie rod end -2- when doing so.
-
Remove open spring clip -1- from boot.
-
Set toe by twisting the left and/or right tie rod.
To do this, position open-end wrench at hex of tie rod.
Be sure that boots are not twisted after turning tie rods!
Twisted boots wear out quickly.
-
Tighten lock nut with socket SW 24 V.A.G 1332/1 while counterholding tie rod end -1-.
-
Check toe value again.
After tightening lock nut, adjusted value may change slightly.
If the measured toe nevertheless lies within the tolerance, the adjustment is correct.
-
Install open spring clip on boot.
Tightening Specifications