Rabbit L5-2.5L (CBUA) (2008)
Gear Oil, Draining
Use a clean container (3.0 L capacity) with scale to collect gear oil.
-
Drain gear oil by removing oil drain plug -arrow 1- and then pivot pin -arrow 2-.
-
Install journal -arrow 2- with new O-ring
-
Install oil drain plug -arrow 1-
-
Now rotate angle -A- back into initial position -direction of arrow- to let shift rod move freely again
Gear Oil, Filling
Top off gear oil in container to 1.7 L.
-
Remove back-up lamp switch F4 -arrow-.
-
Connect hose (approximately 600 mm long, outside diameter 10 mm) to commercially available funnel.
-
Insert hose into mounting hole of back-up lamp switch (2nd technician) and fill the gear oil.
-
Reinstall back-up lamp switch F4 -arrow-
-
Check function of shift mechanism.
-
Install entire air filter housing.
-
Install noise insulation.