Rabbit L5-25L (CBUA) (2008) Wheel Bearing Service and Repair
/Page-378003.png)
3 - Bolt
^
M12 x 1.5 x 80
^
90 Nm plus an additional 90° turn
^
Always replace after removal
4 - Coupling rod
^
Coupling rod changed in model year 2004
During start of production, coupling rods with two ball joints were revised to coupling rods with one ball joint and a bonded rubber bushing. The side
with the bonded rubber bushing is attached to the stabilizer bar.
A mixed installation is not permitted
^
Connects the stabilizer bar to longitudinal control arm/wheel bearing housing
5 - Bolt
^
90 Nm plus an additional 90° turn
^
Observe tightening sequence
^
Always replace after removal
6 - Trailing link
7 - Bolt
^
8 Nm
8 - Right Rear ABS Wheel Speed Sensor G44 / Left Rear ABS Wheel Speed Sensor G46
^
Can be checked in Guided Fault Finding using the
^
Before inserting sensor, clean inner surface of mounting hole and coat with Polycarbamide grease G 000 650
9 - Wheel Bearing Housing
10 - Bonded rubber bushing
11 - Nut
^
40 Nm
^
Always replace after removal
12 - Bolt
^
4 Nm
13 - Brake disc
14 - Dust cap
^
Always replace after removal
An appropriate seal can only be achieved with a new dust cap.
15 - Bolt
^
M16 x 1.5 x 70
^
180 Nm plus an additional 180° turn
^
Loosen and tighten using socket insert XZN 18 T10162
^
Always replace after removal
16 - Wheel hub with wheel bearing
^
Sensor ring for ABS is installed in wheel hub
The wheel bearing and wheel hub are installed together in a housing.
This wheel bearing/hub unit is maintenance and adjustment free. Adjusting and servicing is not possible!
17 - Bolt
^
12 Nm
18 - Cover plate
