Rabbit L5-2.5L (CBUA) (2008)
Engine Control Module: Testing and Inspection
Engine Control Module DTC Memory, Checking And Erasing
Special tools, testers and auxiliary items required
-
Vehicle diagnostic, testing, and information system VAS 5051
Connect Vehicle Diagnosis, Testing and Information System VAS 5051 as follows:
-
Connect diagnostic cable connector - 2 - to Data Link Connector (DLC) in drivers footwell.
-
Start engine and run at idle speed.
Only if engine does not start:
-
Switch on ignition.
Selecting operating mode:
-
Press button on display for "Vehicle On Board Diagnostic (OBD)".
Selecting vehicle system:
-
Press button "01 - Engine electronics" on display.
The control module identification with coding - 2 - as well as Vehicle Identification Number (VIN) in center area and identification of anti-theft
immobilizer appear on the display.
NOTE: A print-out is available. Press the "print" button if required.
Selecting diagnosis function:
-
Press button "02 - Check DTC memory" on display.
-
If no malfunction is stored in engine control module, "0 DTC(s) detected" is displayed.
-
If malfunctions are stored in the engine control module, these are shown one below another on the display.
-
Press arrow left key.
-
Press button "05 - Erase DTC memory" on display.
-
Press function "06 - End output".
NOTE: If DTC memory was erased, readiness code must be generated anew.