Rabbit L5-2.5L (CBUA) (2008)
Leak Detection Pump: Service and Repair
Leak Detection Pump
Removing
-
Remove right rear wheel housing liner.
-
Disconnect vacuum line - 1 -.
-
Separate electrical connector - 2 -.
-
Disconnect vent line - 3 - by pressing release button.
-
Remove nuts - arrows -.
-
Disengage diagnostic pump with bracket.
Installing
Installation is in reverse order of removal, noting the following:
-
Vent line - 3 - must engage audibly.
-
Install right rear wheel housing liner.
Tightening Specifications
Component
Nm
Bracket for leak detection
8 Nm
pump to wheel housing