Rabbit L5-2.5L (CBUA) (2008)
Headlamp Control Module: Service and Repair
HID Headlamp Control Module
NOTE: Left High-intensity Gas Discharge Lamp Control Module J343 and Right High intensity Gas Discharge Lamp Control Module J344 is not
capable of On Board Diagnostic (OBD).
Removing
-
Remove headlamp
-
Remove mounting bolts - arrows - of High-intensity Gas Discharge Lamp Control Module - 1 -.
NOTE: While removing High-intensity Gas Discharge Lamp Control Module, no harness connectors must be disconnected. Harness connector is
installed permanently on headlamp and is automatically disconnected when removing High-intensity Gas Discharge Lamp Control Module.
-
Remove High-intensity Gas Discharge Lamp Control Module - 1 - from headlamp.
Installing
CAUTION: Make sure seal has proper seating when installing High-intensity Gas Discharge Lamp Control Module. It is destroyed by ingress
of water into headlamp.
Install in reverse order of removal, noting the following:
-
Check headlamp for function.
-
Perform basic setting of headlamp