Rabbit L5-2.5L (CBUA) (2008)
Air Bag Control Module: Service and Repair
Airbag Module, Driver
Airbag Module, Driver
NOTE:
-
Removal and installation of airbag unit is described for multi-function steering wheel.
-
The screwdriver mentioned in the following should be about 175 mm long and have a blade width of 7 mm.
Removing
CAUTION: Observe safety precautions for working on airbags.
-
Disconnect vehicle battery
-
Adjust steering wheel height so that it is located in the highest position.
-
Adjust steering wheel depth (reach) so it is in the fully extended position.
-
Turn steering wheel into the position depicted.
-
Insert a screwdriver into hole on rear side of steering wheel until it stops (approx. 8 mm).
-
Turn the screwdriver in the direction of passengers side door - arrow - ; this unlocks the airbag unit locking frame on the right side of the steering
wheel.
-
Turn steering wheel 180 degrees and disengage airbag unit locking mechanism on left side of steering wheel as described.
-
Turn steering wheel back 90 degrees into center position.
-
Remove airbag unit from steering wheel.