Rabbit L5-2.5L (CBUA) (2008)
Headlamp Alignment Sensor: Service and Repair
Left Rear HID Level Control System Sensor
Left Rear HID Level Control System Sensor
A vehicle level sensor is located at front axle (Left Front Level Control System Sensor G78) and (Left Rear Level Control System Sensor G76) is located
at rear axle.
NOTE:
-
If the vehicle level sensors are replaced, the values of the sensor must be checked and basic setting of headlamps must be performed
-
If values of vehicle level sensors are outside the tolerance range, basic setting of headlamps cannot be performed.
Removing
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Disconnect connector - arrow -.
-
Remove mounting bolts - 1 - and remove Left Rear Level Control System Sensor G76 - 2 -.
Installing
Install in reverse order of removal, noting the following:
-
Tighten all threaded connections to the specification
-
Check Left Rear Level Control System Sensor G76
-
Perform basic setting of headlamp
NOTE:
-
If the vehicle level sensors are replaced, the values of the sensor must be checked and basic setting of headlamps must be performed
-
If values of vehicle level sensors are outside the tolerance range, basic setting of headlamps cannot be performed.