Rabbit L5-2.5L (CBUA) (2008)
Oxygen Sensor: Service and Repair
6-Pin Universal Oxygen Sensor
6-Pin Universal Oxygen Sensor
NOTE:
-
Use the faulty sensor as a guide for installing all of the accompanying attachments, cable ties or marking bands.
-
Do not crimp or cut the wires. The oxygen sensor function will be affected.
-
If necessary, identify the oxygen sensor by the protective pipe.
-
Remove the old oxygen sensor.
-
Lay both of the oxygen sensor next to each other so the sensor housings are the same level.
-
Tie the excess length of the sensor (approximately 50 to 250 mm) back so it is the same length as the faulty sensor and secure it with cable ties - 1
-.
-
Install the new oxygen sensor in the vehicle.