Rabbit L5-2.5L (CBUA) (2008)
/Page-245028.png)
-
Thread pressure hose - 6 - , Seat Occupied Recognition Pressure Sensor G452 - 7 - , Seat Occupied Recognition Control Module J706 - 9 - and
seat wiring harness - 8 - through opening - arrow - on seat frame - 5 -.
Passenger Occupant Detection System Repair Set, Power Seats
Passenger Occupant Detection System Repair Set, Power Seats
NOTE:
-
Passenger Occupant Detection System (PODS) controls automatic passenger airbag deactivation.
-
This equipment is only installed on vehicles released in the USA.
-
When installing, there must be no wiring harness of seat heater between upholstery and mat for seat occupied recognition.
-
Pressure hose must be routed without kinking.
-
Stickers with notes on harness connectors must not be damaged.
-
After being connected to the vehicle electrical system, verify that the replaced components can move easily by moving the seat.
After replacing seat occupied recognition, basic setting of seat occupied recognition must be performed using diagnostic tester containing "Guided
Fault Finding" .
CAUTION: Basic setting must be performed when seat is not occupied.
Installation is reverse of removal, noting the following:
