Rabbit L5-2.5L (CBUA) (2008)
-
Use Hose Clamp 3094 to clamp supply hose to master cylinder.
-
Using a screwdriver disengage securing clip -2- and pull out of master cylinder until it stops.
-
Disconnect hose/line assembly -1- from master cylinder and plug it.
All vehicles
-
Disconnect electrical connector -4-.
-
Unclip Clutch Position Sensor G476 on master cylinder -arrow- and remove.
Installing
Installation is performed in reverse order of removal. Note the following:
Note:
^
Replace seals.
^
Replace hose clamps.
^
Allocate all components.
If hose/line assembly was removed:
-
Press in hose/line assembly -1- with new sealing ring -2- to connection of master cylinder -4- until securing clip -3- engages audibly.
-
Verify by pulling on hose/line assembly.
All vehicles
-
Install battery carrier and battery.
-
Install complete air filter housing, if it is located in the vicinity of the battery.
-
Connect battery and observe the work procedures for after connecting the battery.