Rabbit L5-2.5L (CBUA) (2008)
-
Disengage securing clip -2- using a screwdriver and pull out of master cylinder until it stops.
-
Disconnect hose/line assembly -1- from master cylinder and plug it.
Continuation for All
-
Disconnect electrical connector -4-.
-
Unclip clutch position sensor G476 on master cylinder -arrow- and remove.
Installing
Installation is performed in the reverse order of removal. Pay attention to the following:
Note:
^
Replace hose clamps.
^
Allocate all components.
If The Hose/Line Assembly was Removed
-
Press the hose/line assembly -1- with the O-ring -2- into the master cylinder connection -4- until the securing clip -3- engages audibly.
-
Verify by pulling on hose/line assembly.
-
After removing the hose clamp 3094, bring the return hose back to its original shape.
-
Bleed the clutch system.
Continuation for All
-
Install battery carrier and battery.
-
If removed, install entire air filter housing.
-
Connect the battery and observe the work procedures for after connecting the battery.