Rabbit L5-2.5L (CBUA) (2008)
/Page-1265002.png)
^
Always replace after removal
8 - Left Front Level Control System Sensor G78
^
Can be checked in Guided Fault Finding
9 - Bolt
^
9 Nm
10 - Control arm
^
Description: Cast steel
^
If damaged, also replace lower ball joint
11 - Control arm
^
Description: Steel plate
^
If damaged, also replace lower ball joint
12 - Nut
^
M12 x 1.5
^
60 Nm
^
Self-locking
^
Always replace after removal
13 - Ball joint
^
Replace when control arm is damaged
14 - Nut
^
60 Nm
^
Self-locking
^
Always replace after removal
15 - Nut
^
9 Nm
16 - Bolt
^
M12 x 1.5 x 100
^
70 Nm plus an additional 90° turn
^
Always replace after removal
17 - Bolt
^
20 Nm plus an additional 90° turn
^
Always replace after removal
18 - Bolt
^
M12 x 1.5 x 75
^
70 Nm plus an additional 90° turn
^
Always replace after removal
19 - Bolt
^
M14 x 1.5 x 70
^
100 Nm plus an additional 90° turn
^
Only tighten if pendulum support is bolted to transmission
^
Always replace after removal
20 - Underbody protection bracket
21 - Bolt
Always pay attention to the size and strength class of the bolts. There are different tightening specifications.
^
M10 x 75 strength class 8.8: 40 Nm plus an additional 90° turn
^
M10 x 75 strength class 10.9: 50 Nm plus an additional 90° turn
CAUTION! From model year 2008, Heli-Coil inserts are installed in the threads for the pendulum support threaded connection in the 02Q
manual transmissions.
On these and all other transmissions, use strength class 10.9 bolts.
If, in the 02Q manual transmissions, there is not Heli-Coil insert, then use 8.8 strength class bolts and the appropriate tightening
specification.
^
Always replace after removal
22 - Bolt
Always pay attention to the bolt strength class. There are different tightening specifications.
^
M10 x 35 strength class 8.8: 40 Nm plus an additional 90° turn
^
M10 x 35 strength class 10.9: 50 Nm plus an additional 90° turn
CAUTION! From model year 2008, Heli-Coil inserts are installed in the threads for the pendulum support threaded connection in the 02Q
manual transmissions.
On these and all other transmissions, use strength class 10.9 bolts.
If, in the 02Q manual transmissions, there is not Heli-Coil insert, then use 8.8 strength class bolts and the appropriate tightening
specification.
